Looking to sell the RX7 and go M3

Messages
26
Likes
0
Location
Emerald Coast
#1
Ya, i am going to sell my RX7 and give my sister my 328is and get an E36 M3. So first of all, anyone know of any good M3's for sale? And my next question is, and i am sure its ben asked before, befcasue i see it all the time on RX7club.com.... but what would you do as far as mods? looking to spend about 4-5g in uprades. I know of a few small reliablity mods. And i have seen some packages on TMS, any perfered packages? Thanx for the input.
KB
 
Messages
4,412
Likes
5
Location
Wayzata, MN
#6
a friend of mine known as "blunt" has done a lot of things to his, the best thing he did was roll it the obd2 (3.2l) motor back to obd1, that got him 15-20 net bhp
 
Messages
413
Likes
0
Location
GA
#8
as far as na tunes, what I am going to do. I'm going to do the larger air mass flow sensor, intake system, larger throttle body, shrick cams, shrick intake manifold, and custom chip. Which plus my exhaust system. All of these mods are good for 80hp.(Also 3700 installed at mt local shop) i also have an lightweight flywheel. Right now all i have is the lightweight flywheel, sharked, B&B exhaust, and shark injector. My 0-60 is 5.4 and my 0-100 stock is 14.5. Last time i got it clock it ran a 0-100 @ 13.8. I could not believe the car ran that good. We even repeated it many times the best time was 13.8 0-100. I am really looking forward to those mods.
 
Messages
766
Likes
0
Location
Ames, IA / St. Paul, MN
#12
frolf said:
i was looking more for a ratio, i don't think i'd buy a 3rd party diff. it'd be too much money, you can just pull them off of older bimmers.
Can't argue with a lifetime warranty under racing condtions...

3.73 should provide good top end as well as brisk acceleration.
 
Messages
4,412
Likes
5
Location
Wayzata, MN
#13
its a tough call. but i've considered getting a 315 lsd on my car instead of my 293 328 rear end, i could probably get the 315 for $20+ shipping from a friend.

money talks for me in this situation.
 
Last edited:


Top