325ix Brake Linning light is on
- Thread starter 325ix
- Start date
You need to check your brake pads. If they are OK, you need to replace the brake pad wear sensors (2x). One is on the front (LHS I think) and the other is on the rear ono the opposite side to the front one.
Is is a smalll sensor which "plugs in" to your brake pad and not everyone replaces it with a new set of pads like they should. I personally don't see the point as I check my pad wear regularly myself, but I put up with the light shining at me all the time.
Is is a smalll sensor which "plugs in" to your brake pad and not everyone replaces it with a new set of pads like they should. I personally don't see the point as I check my pad wear regularly myself, but I put up with the light shining at me all the time.
You may just have a loose connection on one of the two wires.. they're easy to find... front driver side(left) and rear passenger(right)... check the little plugs or check your pads... if one of the sensors is touching the disc, it's time for pad replacement.
If all your connections are fine and your pads are fine, you can either take the old sensor wire and short the two wires, or you can just remove the dash and pull the bulb out. removing the instrument cluster and reinstalling it takes about 20 minutes.
Your windows fog up because it too damn cold in Ottawa! You're gunna have some fun with that "ix" this weekend with this snow storm we're going to get!
If all your connections are fine and your pads are fine, you can either take the old sensor wire and short the two wires, or you can just remove the dash and pull the bulb out. removing the instrument cluster and reinstalling it takes about 20 minutes.
Your windows fog up because it too damn cold in Ottawa! You're gunna have some fun with that "ix" this weekend with this snow storm we're going to get!
![[:p]](/images/smilies/tongue.png "Stick Out Tongue [:p]")